When using the Bluetooth? Headset for the first time, the Bluetooth? Headset and the
配對
當首次使用藍牙耳機，藍牙耳機和FTM-10R必須配對。
FTM-10R must be paired.
1.
Turn the transceiver off.
關閉收發器的電源。
2.
Press and hold the [POWER] key while turning the power on again.
再次按住[POWER]鍵，接通電源時。
3.
Press and hold the [VOL/SEL] key for one second to activate the Menu Mode.
按住[VOL/ SEL]鍵一秒鐘，以激活菜單模式。
4.
Rotate the DIAL knob to select the Bluetooth? Adapter Unit you wish to pair.
旋轉DIAL旋鈕選擇藍牙?適配器的單位，你想配對。
Main Chassis’s Bluetooth? Adapter Unit: Menu Item “SF6BLTH R”
主機箱的藍牙?適配器單位：菜單項“SF6 BLTH R”
Front Panel’s Bluetooth? Adapter Unit: Menu Item “SF7BLTH F”
前面板的藍牙?適配器單位：菜單項“SF7 BLTH F“
5. Press the PTT key.
按PTT鍵。
The current PIN code appears.
當前PIN碼出現。
When perform pairing of BH-1 Bluetooth? Headset, skipto the next step. Otherwise, set the PIN number of the當執行BH-1藍牙耳機配對，跳過下一步。否則，設置PIN號碼
Bluetooth? Unit:
1.
Following operation of step 4 (press the PTT key), rotatethe DIAL knob to set the first digit of the PIN code.
以下操作步驟4（按PTT鍵），旋轉DIAL旋鈕設置PIN碼的第一個數字。
2. Press the key to save the first digit of the PIN code and move on to the next place.
按鍵保存第一個數字的PIN碼和移動到下一個地方。
2.
Repeat the previous steps to complete the PIN code. If you make a mistake, press the
key to move back to the incorrect number, then re-enter the correct number.
